Fixing a few holes in my aluminum radiator with Stic-Tite. Stic-Tite is a plastic string that works like solder. Heat the aluminum with a propane torch and feed in the Stic-Tite just like solder. It will melt and fill in the hole. The plastic will stick to the aluminum and seal up any leaks.
If you have ever had a roof that leaked you might be curious to see who we solved the leaks on an old 18 wheel trailer that is used for storage. Not just water was a problem but also the ever curious pack rat and if you have had one of those varmints invade you know the mess and damage they can cause. We went to an 18 wheel trailer repair shop and for a reasonable price bought rolled aluminum, $18 per linear foot, and have completely sealed off the roof. Can you say thank you silicon and expanding spray foam? And it actually looks nice. Check out 3:56 to see the finished product. Lot’s of fun working on this. Some good old farmer ingenuity. If you have any questions or comments please leave them and I will get back with you. Daniel
Click to Subscribe! ► – Im in the workshop today, repairing a blown bead lock and tire. The extreme cold water I was in ( caused the rubber to constrict around the plastic rim and pull out of the bead lock right in the middle of my run that day. So, today I figured I would go over tire repair on a scale crawler and touch on some of the basics. Want to come and hang out with me, then click play on the video bar! Grab your RC, and start wrenching along with me.. let’s get some maintenance done.
Simple repair could save you money from purchasing new fittings. Even new fittings seem to leak after a couple uses, o-ring solution might work for ya !
On the video I call it a quick disconnect but many refer it to quick connect.
All content created by The Tool Review is for entertainment purposes only. Some or all of the information may not be accurate and should not be used for educational purposes.
By continuing to watch this video, you agree to view at your own risk.
*The Tool Review*
EMPHASIS ON DIY! A customer needed a quick frame patch on his 57 chevy, We didn’t have a good section of channel to just cut & weld in. So, I did it this way. If you dont care too terribly much about how it looks this is a fine method. Did this in a few hours. This is going to be a rat rod, so I like showing the hard lines of what I have done. I have also repaired frames with a formed channel being placed inside or outside the original frame- but that is more costly for the customer.
For more how to videos make sure to check out & subscribe to my channel!!
– A simple video on how to Replace your Vehicle’s Car Battery. Please visit my website for more advice, tips, and general auto advice. If you have any questions or concerns it would be best to send me an email via my website. I try to check comments on this video but may not see the question unless you directly send me an email.
If you got value out of my video and it helped you change your own car battery, I’d appreciate it if you used my Amazon affiliiate link:
This will help me make more DIY auto repair videos in the future and not cost you anything.
My Auto Blog:
Follow me on Twitter:
My Singing Dogs:
how to replace a car battery
replacing a car battery
install a car battery
how to install a car battery
how to install and remove a car battery
removing a car battery
installing a car battery
replace car battery
replace a car battery
how to replace a car battery on a chyrlser van
how to replace a car battery on dodge caravan
chrysler town and country
town and country
97 town and country
car does not start
car not starting
car cranks but doesn’t start